How to BRASS PUSH IN Female Bulkhead Union

Installing a brass push-in female bulkhead union is a straightforward process that requires minimal tools and expertise. Follow these steps to properly install the union in your fluid or pneumatic system:

Tools and Materials Needed:

Tubing (if applicable)

Tubing cutter (if needed)

Wrench or pliers (for tightening, if necessary)

Installation Steps:

Preparation:

Ensure that the system is depressurized and turned off before beginning the installation process.

Selecting the Installation Location:

Choose the appropriate location on the barrier or panel where you intend to install the bulkhead union. Make sure there is enough space to accommodate the union and any associated tubing.

Cutting Tubing (If Applicable):

If you are connecting tubing to the bulkhead union, use a tubing cutter to cut the tubing to the desired length. Make sure the cut is clean and square to ensure a proper seal.

Insertion of Bulkhead Union:

Insert one end of the brass push-in female bulkhead union through the chosen hole in the barrier or panel. The threaded portion should be on the side where you intend to connect the tubing.

Tightening the Nut:

On the other side of the barrier or panel, secure the bulkhead union in place by threading the nut onto the union's threaded portion. Use a wrench or pliers to tighten the nut snugly against the barrier or panel. Be careful not to overtighten, as it could damage the threads or the barrier.

Connecting Tubing (If Applicable):

If you are connecting tubing to the bulkhead union, insert the end of the tubing into the push-in fitting on the threaded end of the union. Push the tubing firmly until it locks into place. Give it a slight tug to ensure a secure connection.

Testing the Connection:

Turn on the fluid or air system and check for any leaks around the connection points. If you detect any leaks, you may need to tighten the nut or recheck the tubing connection.

Final Check:

Once the connection is secure and leak-free, ensure that the tubing is not kinked or bent excessively, as this can affect the flow of fluids or air.

Safety Precautions:

Always follow manufacturer guidelines and recommendations when installing any components.

Ensure that the system is depressurized and turned off before installation.

If working with pressurized systems, take necessary precautions to prevent accidental release of pressure.

Keep in mind that installation steps might vary slightly depending on the specific design of the brass push-in female bulkhead union and the system you are working with. Always refer to the manufacturer's instructions and guidelines for the most accurate and up-to-date installation process.